Gonzales Wood
Quote

How to Measure for a Door

4 min read

Accurate measurements are the foundation of a door that fits and swings cleanly. Whether you're replacing an existing door or building a new opening, here's exactly what to measure and how.

What you'll need

A metal tape measure, a pen and paper, and a few minutes. Measure in millimetres or inches — just be consistent and tell us which.

For a replacement door (measuring the slab)

  1. 1Width: measure across the door face at the top, middle and bottom. Use the largest figure.
  2. 2Height: measure both sides and the centre, top to bottom. Use the largest figure.
  3. 3Thickness: measure the edge of the door. Common solid doors are 35mm (1⅜") or 45mm (1¾").
  4. 4Note the hinge side and which way it swings (see our door-handing guide).

For a new opening (measuring the frame)

  1. 1Opening width: measure wall-to-wall inside the rough opening at top, middle and bottom; use the smallest figure.
  2. 2Opening height: measure floor to header at both sides; use the smallest figure.
  3. 3Wall / jamb depth: measure the wall thickness the frame must wrap, including any plaster or cladding.

Jamb depth matters

The jamb is the frame the door hangs in. If your wall is thicker or thinner than standard, the jamb is made to match so the casing sits flush on both sides. Always include the full finished wall thickness.

  • When in doubt, send photos with your measurements — our team will sanity-check them before production.